Alienware 17 R4 Service Manual

PDF

Procedure

  1. Note the cable routing and remove the antenna cables from the routing guides on the computer base.
  2. Disconnect the tron-light cable from the system board.
  3. Disconnect the tron-light cable from the system board.
    Image: Disconnecting tron-light cables
  4. Remove the two screws (M2.5x5) that secure the computer base to the palm-rest assembly.
  5. Remove the 14 screws (M2.5x8) that secure the computer base to the palm-rest assembly.
    Image: Removing the screws that secure the computer base
  6. Using a plastic scribe, gently release the tabs on the computer base from the slots on the palm-rest assembly.
  7. Lift the computer base off the palm-rest assembly.
    Image: Removing computer base

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\