Alienware 17 R4 Service Manual

PDF

Procedure

  1. Connect the interposer to the hard drive.
  2. Align the screw holes on the hard-drive bracket with the screw holes on the hard-drive assembly.
  3. Replace the four screws (M3x3) that secure the hard-drive bracket to the hard-drive assembly.
  4. Align the screw holes on the hard-drive assembly with the screw holes on the computer base.
  5. Replace the four screws (M2.5x5) that secure the hard-drive assembly to the computer base.
  6. Route the hard-drive cable through the routing guides on the computer base.
  7. Connect the hard-drive cable to the system board.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\