Alienware 17 R4 Service Manual

PDF

Procedure

  1. Align the screw holes on the display hinges with the screw holes on the display back-cover and antenna assembly.
  2. Replace the 12 screws (M2.5x3) that secure the display hinges to the display back-cover and antenna assembly.
  3. Replace the tape that secures the display hinge to the display back-cover and antenna assembly.
  4. Route the antenna cables, power-button board cable, logo-board cable, tobii eye-tracker board cable, and display cable through the routing guides on the display back-cover and antenna assembly.
  5. Turn the display assembly over.
  6. Place the hinge caps on the display hinges and press down to snap them into place.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\