Alienware 17 R4 Service Manual

PDF

Procedure

  1. Connect the subwoofer cable to the I/O board.
  2. Turn the I/O board over.
  3. Using the alignment posts, place the I/O board on the palm-rest assembly and align the screw holes on the I/O board with the screw holes on the palm-rest assembly.
  4. Replace the two screws (M2.5x5) that secure the I/O board to the palm-rest assembly.
  5. Slide the I/O-board cable into the connector on the I/O board and close the latch to secure the cable.
  6. Adhere the tape that secures the I/O-board cable to the I/O board.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\