Installing An
Expansion Card Into The Expansion-Card Riser 2 and 3
CAUTION:Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized
in your product documentation, or as directed by the online or telephone
service and support team. Damage due to servicing that is not authorized
by Dell is not covered by your warranty. Read and follow the safety
instructions that came with the product.
Unpack the expansion card and prepare it for installation.
For instructions, see the documentation accompanying the card.
Turn off the system, including any attached peripherals,
and disconnect the system from the electrical outlet and peripherals.
Open the system.
Remove the expansion-card riser cage by sliding the black
handle in the direction of the blue arrows and then lift the riser
straight up.
Remove the expansion-card latch holding the expansion-card.
Holding the card by its edges, position the card so that
the card-edge connector aligns with the expansion-card connector.
Insert the card-edge connector firmly into the expansion-card
connector until the card is fully seated.
Insert the expansion-card latch.
If applicable, connect any cables to the expansion card.
Install the expansion-card riser.
Close the system.
Reconnect the system to its electrical outlet and turn
the system on, including any attached peripherals.
Install any device drivers required for the card as described
in the documentation for the card.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\