Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge R920 System Owner's Manual

PDF

Removing The Power Supply Bay

CAUTION:Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
  2. Open the system.
  3. As applicable, remove the AC or DC power supply and power supply blanks from the power supply bay.
  4. Remove the storage controller card (applicable for the left power supply bay).
  5. If applicable, remove the optional riser 2 and 3.
  6. Press the spring latch (with your index finger and thumb) on top of the power supply bay and pull the bay away from the chassis side wall.
  7. Pull the power supply bay, so that the PDB is disconnected from the connector on the system board.
    Follow the same procedure for the removal of other power supply bay in the system.
Figure 1. Removing and Installing the Power Supply Bay
This figure shows removing and installing the Power Supply Bay.
  1. PDB connector on the system board
  2. PDB
  3. power supply bay (left)
  4. power supply bay (right)
  5. finger grips on the power supply bay

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\