- Notes, cautions, and warnings
- About your system
- Using the system setup and boot manager
- Installing and removing system components
- Recommended Tools
- Front bezel (optional)
- System cover
- Inside The System
- Cable Management Tray
- System Memory
- General Memory Module Installation Guidelines
- Mode-Specific Guidelines
- Advanced ECC (Lockstep)
- Memory optimized independent channel mode
- Memory sparing
- Memory mirroring
- Fault Resilient Memory
- Sample Memory Configurations
- Removing A Memory-Riser Blank
- Installing A Memory-Riser Blank
- Removing A Memory Riser
- Installing A Memory Riser
- Removing Memory Modules From The Memory Riser
- Installing Memory Modules
- Memory Riser And Fan Cage
- Hard drives
- Optical Drive (Optional)
- Cooling Fans
- Internal USB Memory Key (Optional)
- Expansion Cards And Expansion-Card Risers
- Expansion Card Installation Guidelines
- Removing The Left Expansion Card Riser Blank
- Installing The Left Expansion Card Riser Blank
- Removing The Right Expansion Card Riser Blank
- Removing An Expansion Card From Expansion-Card Risers 2 and 3
- Installing An Expansion Card Into The Expansion-Card Riser 2 and 3
- NDC Riser (I/O Riser 1)
- Network Daughter Card
- SD vFlash card
- Internal Dual SD Module
- Internal SD card
- Integrated Storage Controller Card
- RAID Battery
- Processors
- Power Supplies
- Hot Spare Feature
- Removing an AC power supply
- Installing an AC power supply
- Wiring instructions for a DC power supply
- Assembling And Connecting The Safety Ground Wire
- Assembling The DC Input Power Wires
- Removing A DC Power Supply
- Installing A DC Power Supply
- Removing The Power Supply Blank
- Installing The Power Supply Blank
- Power Distribution Board
- System battery
- Hard-Drive Backplane
- SAS Expander Daughter Card
- Control panel assembly
- System board
- Troubleshooting your system
- Minimum configuration to POST
- Troubleshooting system startup failure
- Troubleshooting external connections
- Troubleshooting the video subsystem
- Troubleshooting a USB device
- Troubleshooting a serial I/O device
- Troubleshooting a wet system
- Troubleshooting a damaged system
- Troubleshooting the system battery
- Troubleshooting power supply units
- Troubleshooting Cooling Problems
- Troubleshooting cooling fans
- Troubleshooting system memory
- Troubleshooting an internal USB key
- Troubleshooting an SD card
- Troubleshooting an optical drive
- Troubleshooting A Hard Drive
- Troubleshooting a storage controller
- Troubleshooting expansion cards
- Troubleshooting Processors
- Using system diagnostics
- Jumpers and connectors
- Technical Specifications
- System messages
- Getting help
Dell PowerEdge R920 System Owner's Manual
Processors
Use the following
procedure when:
- Installing an additional processor
- Replacing a processor
Your system supports two types of processor configurations:
- Four-processor configuration
- Two-processor configuration
NOTE:To ensure
proper system cooling, you must install a processor blank and a heat-sink
blank in any empty processor socket.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\