Secure Connect Gateway REST API Guide

PDF

Device discovery rules

A device discovery rule enables you to add devices in secure connect gateway based on IP address ranges or comma-separated hostname expressions or IP addresses.

The following table describes the parameters that are used to manage device discovery rules:

Table 1. ParametersThe following table describes the parameters that are used to manage device discovery rules.
Parameter	Description
createdOn	Date when the rule was created.
credProfileId	Identifier for the credential profile
enableMonitoring	Specifies whether monitoring must be enabled for the discovered devices.
ipList	IP addresses of the devices that must be discovered by the rule
ipRanges	IP range of the devices that must be discovered by the rule
isDeepDiscovery	Specifies whether deep discovery must be performed on the discovered devices.
isRecurring	Specifies whether the rule is set to recur.
isSNMPConfig	Specifies whether SNMP settings must be configured on the discovered devices.
lastRunOn	Date and time when the rule was last run.
name	Name of the rule
nextTriggeredDate	Date when the rule runs again
ruleId	Identifier for the rule
selectedDeviceTypes	List of device types as specified in the secure connect gateway user interface
status	Running status of the rule