Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Precision 7960 Tower Service Manual

PDF

Installing the front-NVMe module

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the front-NVMe module and provide a visual representation of the installation procedure.

Installing the front-NVMe module

Steps

  1. Align the screw holes on the front-NVMe module with the screw holes on the flex1.
  2. Place the front-NVMe module into the slot in the flex1.
  3. Install the two screws (6-32) to secure the front-NVMe module to the flex1.
  4. Connect the thermal-sensor cable and fan-controller cable to the connectors on the power-distribution board.
  5. Connect the power cable (P5) and data cable to the connectors on the HSBP board.
    NOTE:
    • Follow the same procedure to install the front-NVMe module into the flex0.
    • The HSBP power dongle-cable is required when both flex0 and flex1 is installed with NVMe module.

Next steps

  1. Install the right-side cover.
  2. Install the external solid-state drive assembly
  3. Follow the procedure in After working inside your computer.
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\