NOTE:When removing screws from a component, it is recommended to note the screw type, and the quantity of screws, and then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is restored when the component is replaced.
NOTE:Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when replacing a component.
NOTE:Screw color may vary with the configuration ordered.
Table 1. Screw listThe following table provides the different screws that are used in your
Precision 7960 Tower.
Component
Screw type
Quantity
Screw image
Optical-drive/hard-drive cage
6-32
4
Right-side cover
6-32
2
Front-I/O bracket
Thumb screw
1
Front-I/O board
6-32
3
Heat-sink assembly
Captive screw
4
Front system-fan assembly
Captive screw
6-32
2
3
Rear system-fan assembly
6-32
2
Bottom-air shroud
M3
5
Top cover
6-32
4
Power-distribution board
6-32
4
Front SATA/SAS hard-drive module
6-32
4
Front-NVMe module
6-32
2
Front SATA hard-drive module
6-32
4
Rear SATA/SAS module
6-32
2
Rear-NVMe module
6-32
2
System board
6-32
13
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\