Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Precision 7960 Tower Service Manual

PDF

Installing the Thunderbolt 4 PCIe card

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the Thunderbolt 4 PCIe card and provide a visual representation of the installation procedure.

Installing the Thunderbolt 4 PCIe card

Steps

  1. Push the PCIe latch to open the PCIe door.
  2. Align the Thunderbolt 4 PCIe card with the expansion-card slot on the system board.
  3. Using the alignment post, connect the Thunderbolt 4 PCIe card to the connector and press down firmly. Ensure that the Thunderbolt 4 PCIe card is firmly seated.
  4. Route the Thunderbolt 4 PCIe through the routing clip on the chassis.
  5. Connect the Thunderbolt 4 PCIe cable to the connector on the system board.
  6. Close the PCIe door.

Next steps

  1. Install the air shroud.
  2. Install the left-side cover.
  3. Follow the procedure in After working inside your computer.
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\