During the migration process, NetWorker creates resources to replace each Group resource, and then migrates the Group configuration attributes from the 8.2.x and earlier resources to the new
NetWorker 19.7 resources.
Resource migration for group resources when Snapshot is enabled
The following table summarizes the Group attribute values that migrate to NetWorker
19.7 resources attributes, when the group is Snapshot enabled.
Table 1. Migration of Group attributesThis table provides details about migration of group attributes.
19.7 Resource type
19.7 Resource name
Migration process overview
Attribute values that are migrated from Group resource
Policy
Backup
One policy resource that is called Backup appears and contains all migrated information for all NetWorker group resources that back up file system.
Not applicable
Protection Group
Snapshot
One protection group resource appears for all Snapshot policies.
Protection Group
Name of the Group resource
One Protection Group resource appears for each migrated Group resource. Each Protection Group contains the same client resources that were associated with the pre-19.7 group resource.
Comment
Workflow
Name of the Group resource
One Workflow resource appears for each migrated Group resource. Each Workflow resource is associated with the Protection Group resource that was created for the migrated Group resource.
Autostart
Start Time
Next Start
Interval
Restart Window
End Time attribute value is set to Start Time+(Interval*(n-1))
If the Probe backup group attribute was enabled, the following values are migrated:
Probe Interval—To the Interval attribute
Probe Start Time—To the Start Time attribute
Probe End Time—To the End Time attribute
Probe
Probe
The Probe action resource appears when the Probe based group attribute was enabled in the pre-19.7 migrated group.
Not applicable
Action—Snapshot backup
Backup
The Snapshot Backup action appears for a Group resource that has the Snapshot attribute enabled.
Parallelism
Retries
Retry delay
Success Threshold
Option attributes:
No save, Verbose, Estimate, Verify Synthetic Full, Revert to full when Synthetic Full fails
Min expiration = (1440/(backups per day/retain count))-10
If Retain snapshot=0, then Backup snapshots attribute is set to ALL
Action—Clone
Clone
The Clone action resource appears when the Clone attribute was enabled in the Group resource.
Clone Pool—To the Destination Pool attribute
NOTE The
NetWorker Updating from a Previous Release Guide provides details about resources that are migrated during the update process.
Considerations about migration
A clone action is created for every backup action. The clone action moves snapshot data to media.
A NetWorker 8.2.x snapshot policy resource that was configured for
nth snapshot is not migrated to NetWorker 19.6, and a clone action is not created.
For example, for a NetWorker 8.2.2 snapshot policy of 1-1-day-All resolves to take 1 snapshot, retain 1, expire snapshots every day, and rollover the data to the rollover device. After the migration a clone action is created to backup every snapshot. This means the rollover action in 8.2.x translates to a clone action in 9.2.x and later.
Each backup action within snapshot policy is followed by a clone action. Clone actions have filtering options. Check whether filtering meets the backup requirements of NetWorker Snapshot Management.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\