Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

PDF

Configure a VLT port channel

A VLT port channel, also known as a virtual link trunk, links an attached device and VLT peer switches. OS10 supports a maximum of 128 VLT port channels per node.

  1. Enter the port channel ID number on the VLT peer in INTERFACE mode, from 1 to 128. 
    interface port-channel id-number
  2. Assign the same ID to a VLT port channel on each VLT peer. The peers are seen as a single switch to downstream devices.
    vlt-port-channel vlt-port-channel-id
  3. Repeat the steps on the VLT peer.

Configure VLT port channel — peer 1

OS10(config)# interface port-channel 20
OS10(conf-if-po-20)# vlt-port-channel 20

Configure VLT port channel — peer 2

OS10(config)# interface port-channel 20
OS10(conf-if-po-20)# vlt-port-channel 20

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\