Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

PDF

sflow collector

Configures an sFlow collector IP address where sFlow datagrams are forwarded. You can configure a maximum of two collectors.

Syntax
sflow collector {ipv4-address | ipv6-address} agent-addr {ipv4-address | ipv6-address} [collector-port-number] [max-datagram-size datagram-size-number] [vrf vrf-name]
Parameters
  • ipv4-address | ipv6-address — Enter an IPv4 or IPv6 address in A.B.C.D/A::B format.
  • agent-addr ipv4-address | ipv6-address — Enter the sFlow agent IP address. If you configure two collectors, the agent IP address must be the same for both the collectors.
  • collector-port-number — (Optional) Enter the UDP port number, from 1 to 65535. The default is 6343.
  • max-datagram-size datagram-size-number — (Optional) Enter max-datagram-size then the size number in bytes, from 400 to 1500. The default is 1400.
  • vrf — (Optional) Enter the VRF instance to set the VRF context to the collector IP address. If you do not specify a VRF, the system uses the default VRF.
Defaults
Not configured
Command Modes
CONFIGURATION
Usage Information

You must enter a valid and reachable IPv4 or IPv6 address. If you configure two collectors, traffic samples are sent to both. The sFlow agent address is the IPv4 or IPv6 address used to identify the agent to the collector. The no version of this command removes the configured sFlow collector.

If you specify a nondefault VRF, create the VRF first.

Example
OS10(conf)# sflow collector 10.1.1.1 agent-addr 2.2.2.2 6343 max-datagram-size 1500 vrf default
OS10(conf)# sflow collector 10.1.1.1 agent-addr 2.2.2.2 6343 max-datagram-size 1500 vrf vrf-core
Supported Releases
10.3.0E or later. Updated the command to specify a nondefault VRF on OS10 release 10.4.3.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\