Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

PDF

Additional paths

The add-path command is disabled by default.

  1. Assign an AS number in CONFIGURATION mode.
    router bgp as-number
  2. Enter a neighbor and IP address (A.B.C.D) in ROUTER-BGP mode.
    neighbor ip-address
  3. Enter Address Family mode in ROUTER-NEIGHBOR mode.
    address-family {[ipv4 | ipv6] [unicast])
  4. Allow the specified neighbor to send or receive multiple path advertisements in ROUTER-BGP mode. The count parameter controls the number of paths that are advertised — not the number of paths received.
    add-path [both | received | send] count

Enable additional paths

OS10(config)# router bgp 102
OS10(conf-router-bgp-102)# neighbor 32.1.1.2
OS10(conf-router-neighbor)# address-family ipv4 unicast 
OS10(conf-router-bgp-neighbor-af)# add-path both 3

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\