Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

PDF

Match routes

Configure match criterion for a route-map. There is no limit to the number of match commands per route map, but keep the number of match filters in a route-map low. The set commands do not require a corresponding match command.

  • Match routes with a specific metric value in ROUTE-MAP mode, from 0 to 4294967295.
    match metric metric-value
  • Match routes with a specific tag in ROUTE-MAP mode, from 0 to 4294967295.
    match tag tag-value
  • Match routes whose next hop is a specific interface in ROUTE-MAP mode. 
    match interface interface
    • ethernet — Enter the Ethernet interface information.
    • port-channel — Enter the port-channel number.
    • vlan — Enter the VLAN ID number.

Check match routes

OS10(config)# route-map test permit 1
0S10(conf-route-map)# match tag 250000
OS10(conf-route-map)# set weight 100

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\