Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

PDF

deny (MAC)

Configures a filter to drop packets with a specific MAC address.

Syntax
deny {nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any} {nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any} [protocol-number | capture | cos | count | vlan]
Parameters
  • nn:nn:nn:nn:nn:nn — Enter the MAC address of the network from or to which the packets are sent.
  • 00:00:00:00:00:00 — (Optional) Enter which bits in the MAC address must match. If you do not enter a mask, a mask of 00:00:00:00:00:00 applies.
  • any — (Optional) Set routes which are subject to the filter.
    • protocol-number — (Optional) MAC protocol number identified in the header, from 600 to ffff.
    • capture — (Optional) Capture packets the filter processes.
    • cos — (Optional) CoS value, from 0 to 7.
    • count — (Optional) Count packets the filter processes.
    • vlan — (Optional) VLAN number, from 1 to 4093.
Default
Disabled
Command Mode
MAC-ACL
Usage Information
OS10 cannot count both packets and bytes; when you use the count byte options, only bytes increment. The no version of this command removes the filter.
Example
OS10(config)# mac access-list macacl
OS10(conf-mac-acl)# deny any any cos 7
OS10(conf-mac-acl)# deny any any vlan 2
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\