Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

PDF

logging monitor

Set the minimum severity level for logging to the terminal lines.

Syntax
logging monitor severity severity-level
Parameters
severity-level — Set the minimum logging severity level:
  • log-emerg — Set the system as unusable.
  • log-alert — Set to immediate action is needed.
  • log-crit — Set to critical conditions.
  • log-err — Set to error conditions.
  • log-warning — Set to warning conditions.
  • log-notice — Set to normal but significant conditions, the default.
  • log-info — Set to informational messages.
  • log-debug — Set to debug messages.
Default
Log-notice
Command Mode
CONFIGURATION
Usage Information

To reset the monitor severity to the default level, use the no logging monitor severity command. The default severity level is log-notice.

Supported on the MX9116n and MX5108n switches in Full Switch mode starting in release 10.4.0E(R3S). Also supported in SmartFabric mode starting in release 10.5.0.1.

Example 
OS10(config)# logging monitor severity log-info
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\