Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

PDF

Configure LACP fallback

  1. Enable LACP fallback with the lacp fallback enable command in port channel INTERFACE mode.
  2. Set a timer for receiving LACP PDUs using lacp fallback timeout timer-value in port channel INTERFACE mode.
  3. (Optional) Enable or disable LACP fallback port preemption using lacp fallback preemption {enable | disable} in port channel INTERFACE mode.
Example configuration 
OS10# configure terminal
OS10(config)# interface port-channel 1
OS10(conf-if-po-1)# lacp fallback enable
OS10(conf-if-po-1)# lacp fallback timeout 20
OS10(conf-if-po-1)# lacp fallback preemption enable
View LACP fallback configuration 
OS10# show port-channel summary

Flags:  D - Down    I - member up but inactive    P - member up and active

        U - Up (port-channel) F - Fallback enabled

--------------------------------------------------------------------------------
Group Port-Channel      Type     Protocol  Member Ports
--------------------------------------------------------------------------------

1    port-channel1  (UF) Eth      DYNAMIC   1/1/10(P) 1/1/11(I)

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\