Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

PDF

ip pim bsr-candidate

Configures the router as an IPv4 PIM BSR candidate.

Syntax

ip pim [vrf vrf-name] bsr-candidate {ethernet node/slot/port[:subport] | loopback loopback-interface-number | vlan vlan-number | port-channel port-channel-number} [hash-mask-len length] [priority priority-value]

no ip pim [vrf vrf-name] bsr-candidate

Parameters
  • vrf vrf-name—Enter the keyword vrf, then the name of the VRF
  • loopback-interface-number—Enter a value from 0 to 16383
  • vlan-number—Enter a value from 1 to 4093
  • port-channel-number—Enter a value from 1 to 128
  • length—Enter a value from 0 to 32
  • priority-value—Enter a value from 0 to 255
Default
  • Hash mask length is 30.
  • Priority is 64.
Command Mode
CONFIGURATION
Usage Information

The system advertises the IP address of the specified interface as the BSR IP address in BSR messages. The no form of the command removes the router from being the candidate BSR. Do not specify the parameters in the no form of the command.

Example
OS10# configure terminal
OS10(config)# ip pim vrf red bsr-candidate loopback 10 hash-mask-len 31 priority 11
Supported Releases
10.5.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\