Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

PDF

permit udp

Configures a filter that allows UDP packets meeting the filter criteria.

Syntax
permit udp [A.B.C.D | A.B.C.D/x | any | host ip-address [eq | lt | gt | neq | range]] [[A.B.C.D | A.B.C.D/x | any | host ip-address [eq | lt | gt | neq | range] ] [ack | fin | psh | rst | syn | urg] [capture | count | dscp value | fragment | log]
Parameters
  • A.B.C.D — Enter the IPv4 address in dotted decimal format.
  • A.B.C.D/x — Enter the number of bits that must match the dotted decimal address.
  • any — (Optional) Enter the keyword any to specify any source or destination IP address.
  • host ip-address — (Optional) Enter the IPv4 address to use a host address only.
  • ack — (Optional) Set the bit as acknowledgement.
  • fin — (Optional) Set the bit as finish—no more data from sender.
  • psh — (Optional) Set the bit as push.
  • rst — (Optional) Set the bit as reset.
  • syn — (Optional) Set the bit as synchronize.
  • urg — (Optional) Set the bit set as urgent.
  • capture — (Optional) Capture packets the filter processes.
  • count — (Optional) Count packets the filter processes.
  • byte — (Optional) Count bytes filter processes.
  • dscp value — (Optional) Permit a packet based on the DSCP values, from 0 to 63.
  • fragment — (Optional) Use ACLs to control packet fragments.
  • log — (Optional) Enables ACL logging. Information about packets that match an ACL rule are logged.
  • operator — (Optional) Enter a logical operator to match the packets on the specified port number. The following options are available:
    • eq — (Optional) Permit packets which are equal to.
    • lt — (Optional) Permit packets which are less than.
    • gt — (Optional) Permit packets which are greater than.
    • neq — (Optional) Permit packets which are not equal to.
    • range — (Optional) Permit packets with a specific source and destination address.
      NOTE The control-plane ACL supports only the eq operator.
Default
Not configured
Command Mode
IPV4-ACL
Usage Information
OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The no version of this command removes the filter.
Example
OS10(config)# ip access-list testflow
OS10(conf-ipv4-acl)# permit udp any any capture session 1
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\