Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

PDF

Enable OSPFv3

  1. Enable OSPFv3 globally and configure an OSPFv3 instance in CONFIGURATION mode. 
    router ospfv3 instance-number
  2. Enter the interface information to configure the interface for OSPFv3 in INTERFACE mode. 
    interface ethernet node/slot/port[:subport]
  3. Enable the interface in INTERFACE mode. 
    no shutdown
  4. Disable the default switchport configuration and remove it from an interface or a LAG port in INTERFACE mode. 
    no switchport
  5. Enable the OSPFv3 on an interface in INTERFACE mode. 
    ipv6 ospfv3 process-id area area-id
    • process-id — Enter the OSPFv3 process ID for a specific OSPFv3 process, from 1 to 65535.
    • area-id — Enter the OSPF area ID as an IP address in A.B.C.D format or number, from 1 to 65535.
Enable OSPFv3
OS10(config)# router ospfv3 100
OS10(config-router-ospfv3-100)# exit
OS10(config)#  interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# no shutdown
OS10(conf-if-eth1/1/1)# no switchport
OS10(conf-if-eth1/1/1)# ipv6 ospfv3 300 area 0.0.0.0

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\