Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

PDF

System logging

You can change the system logging default settings using the severity level to control the type of system messages that log. The range of logging severities are:

  • log-emerg—System is unstable.
  • log-alert—Immediate action is needed.
  • log-crit—Critical conditions
  • log-err—Error conditions
  • log-warning—Warning conditions
  • log-notice—Normal, but significant conditions (default)
  • log-info—Informational messages
  • log-debug—Debug messages
  • Enter the minimum severity level for logging to the console in CONFIGURATION mode. 
    logging console severity
  • Enter the minimum severity level for logging to the system log file in CONFIGURATION mode. 
    logging log-file severity
  • Enter the minimum severity level for logging to terminal lines in CONFIGURATION mode. 
    logging monitor severity
  • Configure the remote syslog server in CONFIGURATION mode. 
    logging server {ipv4–address | ipv6–address} [tcp | udp | tls] [port-number] 
[severity severity-level] [vrf {management | vrf-name]

Disable system logging

You can use the no version of any logging command to disable system logging.
  • Disable console logging, and reset the minimum logging severity to the default in CONFIGURATION mode. 
    no logging console severity
  • Disable log-file logging, and reset the minimum logging severity to the default in CONFIGURATION mode. 
    no logging log-file severity
  • Disable monitor logging, and reset the minimum logging severity to the default in CONFIGURATION mode. 
    no logging monitor severity
  • Disable server logging, and reset the minimum logging severity to the default in CONFIGURATION mode. 
    no logging server severity
  • Reenable any logging command in CONFIGURATION mode. 
    no logging enable

Enable server logging for log notice 

OS10(config)# logging server 10.11.86.139 severity log-notice

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\