Latitude 3190 2-in-1 Owner’s Manual

PDF

Installing power connector port

  1. Insert the power connector port into the slot on the computer.
  2. Replace the two M2x3 screws that secure the power connector port to the computer.
  3. Connect the power connector cable to the connector on the system board.
  4. Install the:
    1. battery
    2. base cover
  5. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\