Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

Latitude 3190 2-in-1 Owner’s Manual

Removing display assembly

  1. Follow the procedure in Before working inside your computer.
  2. Remove the:
    1. base cover
    2. battery
  3. To remove cables:
    1. Remove the M2x3 screw [1] and lift the metal bracket that secures the WLAN card on the system board [2].
    2. Disconnect the WLAN cables [3].
    3. Remove the two M2x3 screws [4] and lift the metal bracket that secures the display cable on the computer [5].
    4. Lift the latch, and disconnect the cable [6].
    Image shows removal of display assembly
  4. Disconnect the sensor cable on the system board [1]. Open the palm rest, turn over the system and place it at 90 degree angle with the keyboard facing the table [2].
    Image shows removal of display assembly
  5. To remove the display assembly:
    1. Remove the six M2.5x5 screws that secure the display assembly to the computer [1].
    2. Lift the display assembly from the computer [2].
    Image shows removal of display assembly

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\