Latitude 5290 2-in-1 Owner's Manual

PDF

Removing the battery

  1. Follow the procedure in Before working inside your tablet.
  2. Remove the:
    1. uSIM/micro SD card

      NOTE: : uSIM card slot is available only on tablets shipping with WWAN module.

    2. display panel
  3. To remove the battery:
    1. Release the adhesive tape that secures the battery connector to the system board.
    2. Disconnect the battery cable from the connector on the system board.

      NOTE: : Ensure to pull the cable by the lever of the battery connector, to avoid damage to the pin.

    3. Remove the M2 x 4 screws (4) that secure the battery to the tablet [1].
    4. Lift the battery from the tablet [2].
    The image displays to remove the battery

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\