- Notes, cautions, and warnings
- Working on Your Computer
- Installing the Accessories
- Installing the Power Adapter
- Installing the Dell OptiPlex Micro Dual VESA Mount
- Installing the Dell OptiPlex Micro VESA Mount
- Installing the Dell OptiPlex Micro Vertical Stand
- Installing the Dell OptiPlex Micro Console with DVD-RW
- Installing the Dell OptiPlex Micro All-in-One Mount Behind the Monitor
- List of Compatible Monitor Models
- Removing and Installing Components
- Front and Back View
- Removing the Cover
- Installing the Cover
- Removing the Processor Fan Module
- Installing the Processor Fan Module
- Removing the Speaker
- Installing the Speaker
- Removing the Hard Drive
- Installing the Hard Drive
- Removing the Heatsink
- Installing the Heatsink
- Removing the PS2 and Serial Connector Board
- Installing the PS2 and Serial Connector Board
- Removing the WLAN Card
- Installing the WLAN Card
- Removing the Processor
- Installing the Processor
- Removing the Memory
- Installing the Memory
- Removing the Coin-Cell Battery
- Installing the Coin-Cell Battery
- System Board Layout
- Removing the System Board
- Installing the System Board
- System Setup
- Specifications
- Contacting Dell
Dell OptiPlex 3020M Owner's Manual
Installing the Memory
NOTE: Please use DIMM 2 slot
if there is only one memory module available.
- Align the notch on the memory-card with the tab in the system-board connector.
- Press down on the memory module until the retention clips spring back to secure them in place.
- Install the:
- Follow the procedures in After Working Inside Your Computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\