Dell OptiPlex 3020M Owner's Manual

PDF

Installing the Dell OptiPlex Micro All-in-One Mount Behind the Monitor

Recommended Screws:
Screw TypeUsed with
Figure displaying self-tapping screw.
M4 X L8 mm, pitch 0.7 mm, self-tapping screwPUZ plate without thread screw holes— Dell P,U,PU,UZ- series monitors
Figure displaying PUZ plate without thread screw holes.
Figure displaying machine screw.
M4 X L8 mm, pitch 0.5 mm, machine screwPUZ plate with thread screw holes — Dell P,U,PU,UZ- series monitors
Figure displaying PUZ plate witht thread screw holes.
Figure displaying self-tapping screw.
M3 X L8 mm, pitch 0.5 mm, self-tapping screwE Plate without thread screw holes— Dell E-series monitors
Figure displaying E plate without thread screw holes.
Figure displaying machine screw.
M3 X L8 mm, pitch 0.35 mm, machine screw E Plate with thread screw holes— Dell E-series monitors
Figure displaying E plate with thread screw holes.
U Plate — Universal monitors
Figure displaying U plate.
  1. Perform the following steps as shown in the illustration:
    1. Remove the screws that secure the cover to the chassis [1].
    2. Slide and lift the cover upwards to remove it from the chassis [2].
    Figure displaying how to remove cover.
  2. Perform the following steps as shown in the illustration:
    1. Slide the computer into the slot [1].
    2. Rotate the screw in clockwise direction to secure the computer to the chassis [2].
    Figure displaying how to insert the system.
  3. Perform the following steps as shown in the illustration:
    1. Lift up the antenna cable [1].
    2. Connect the antenna cable to the antenna connector on the computer [2].
    Figure displaying how to connect the antenna cable.
  4. Perform the following steps as shown in the illustration:
    1. Cut the strap of power adapter cable [1].
    2. Slide the power adapter into the slot [2].
    3. Route the cable through the clip [3].
    Figure displaying how to place the power adapter.
  5. Perform the following steps as shown in the illustration:
    1. Route the cable through the clip [1].
    2. Connect the cable to the adapter [2].
    Figure displaying how to connect the power adapter cable.
  6. Align the PUZ plate to the bottom of monitor and tighten the screws.
    Figure displaying how to attach the PUZ plate to the bottom of monitor.
  7. Perform the following steps as shown in the illustration:
    1. Slide and lock the chassis to the PUZ plate [1].
    2. Rotate the screw in clockwise direction to secure the computer [2].
    3. Flip the computer along with the monitor [3].
    Figure displaying how to lock the chassis to PUZ plate.
  8. Perform the following steps as shown in the illustration:
    1. Connect all the cables to the computer.
    2. Slide the cover to its original position [1].
    3. Tighten the screws to secure the cover to the chassis [2].
    Figure displaying how to connect all the cables to the system and how to insert the cover.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\