Dell PowerEdge T360 Installation and Service Manual

BOSS-N1 module kit

The BOSS-N1 module supports up to two M.2 NVMe SSDs.

Before you begin the installation or removal process, follow the safety guidelines and before working inside the system instructions.

Table 1. BOSS-N1 module kit componentsThe table describes the components in the BOSS-N1 module kit.
Components in kit	T360 (quantity)
BOSS-N1 controller card module	1
BOSS-N1 card carrier	1 or 2*
M.2 NVMe SSD	1 or 2*
M.2 NVMe SSD capacity label	1 or 2^†
BOSS-N1 card carrier blank	1
M3 x 0.5 x 4.5 mm screws	1
BOSS-N1 signal cable for mother board (360 mm)	1
BOSS-N1 power cable for mother board (340 mm)	1

NOTE:*The quantity depends on the purchase order.

NOTE:^†The quantity depends on the BOSS-N1 card carrier.

To remove the BOSS blank :

Power off the system.
Use a screwdriver to push out the blank from the BOSS-N1 module blank.

This image shows how to remove the BOSS-N1 module blank — Figure 1. Removing the BOSS-N1 module blank

To install the BOSS blank:

Align the blank with the BOSS-N1 module bay and push it into the bay until it clicks into place.

To install the BOSS-N1 module:

To install the BOSS-N1 module , see Installing the BOSS-N1 card carrier steps 1 to 5.

NOTE:Refer to cable routing section, configuration 49 and 50 for more information on connecting the BOSS cables to system board connectors.

NOTE:Installing the BOSS-N1 card carrier does not require the system to be powered off. System shutdown is only required when installing the BOSS-N1 controller card module.

Welcome

Welcome to Dell

Dell PowerEdge T360 Installation and Service Manual

BOSS-N1 module kit

Rate this content