- Notes, cautions, and warnings
- About this document
- Dell PowerEdge T360 system overview
- Technical specifications
- Chassis dimensions
- System weight
- Processor specifications
- PSU specifications
- Cooling fan specifications
- Supported operating systems
- System battery specifications
- Expansion card riser specifications
- Memory specifications
- Storage controller specifications
- Drives
- Optical drives
- GPU specifications
- Ports and connectors specifications
- Video specifications
- Environmental specifications
- Initial system setup and configuration
- Pre-operating system management applications
- System Setup
- Dell Lifecycle Controller
- Boot Manager
- PXE boot
- Minimum to POST
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Optional front bezel
- System feet
- System cover
- Air shroud
- PCIe air shroud
- Intrusion switch
- Drives
- Removing a drive blank
- Installing a drive blank
- Removing a drive carrier
- Installing the drive carrier
- Removing the drive from the drive carrier
- Installing the drive into the drive carrier
- Removing a 3.5-inch drive adapter from a 3.5-inch drive carrier
- Installing a 3.5-inch adapter into a 3.5-inch drive carrier
- Removing a 2.5-inch drive from the 3.5-inch drive adapter
- Installing a 2.5-inch drive into the 3.5-inch drive adapter
- Optional optical drive
- Drive backplane
- Cooling fans
- Cable routing
- System memory
- Processor and heat sink
- Expansion cards and expansion card risers
- Optional BOSS-N1 module
- Power supply unit
- Power interposer board
- System battery
- System board
- Trusted Platform Module
- Control panel
- Upgrade Kits
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Dell PowerEdge T360 Installation and Service Manual
GPU kit
The GPU kit is available for the Customer. Depending on the kit ordered, the respective components are available.
CAUTION: Do not install GPUs, network cards, or other PCIe devices on your system that are not validated and tested by Dell. Damage caused by unauthorized and invalidated hardware installation will null and void the system warranty.
WARNING: Consumer-Grade GPU should not be installed or used in the Enterprise Server products.
| Components | GPU kit | |
|---|---|---|
| Details | Quantity | |
| Risers | Riser configuration (RC) 1 or 2 | N/A |
| Shroud | PCI shroud | 1 |
| Fans | HPR PCI fan | 1 |
| Heat sinks | Standard or Performance heatsink based on the processor wattage | 1 |
| Cables | Power cable | NA |
| FL - Full Length, HL - Half Length, HPR - High Performance, RC - Riser configuration | ||
NOTE: Adding GPUs to a system may increase the power envelope of that configuration beyond the current power supplies rated capability. Confirm power increase and upgrade PSU as needed to avoid negative impact on performance.
NOTE:See
expansion card installation guidelines for more information about riser configuration supported for the system.
Before you begin, follow the safety guidelines and before working inside the system instructions.
- Remove the air shroud.
- Install the GPU, see
installing an expansion card.
NOTE:For information about riser slot location on the system board, see the system borard jumpers and connectors section.
- Install the High performance (HPR) PCI cooling fan.
- If applicable, connect the power cables to the GPU. To know the connectors for the GPU on the system board, see the
system borard jumpers and connectors section.
See the GPU power cable matrix to know about the requirement of cables for the GPU.
NOTE:A maximum of one SW GPU is supported on the system.
After installing, follow the After working inside the system instructions.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\