Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge T360 Installation and Service Manual

PDF

Removing a 2.5-inch drive from the 3.5-inch drive adapter

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Remove the drive carrier.
  3. Remove 3.5-inch drive adapter from the 3.5-inch drive carrier.
NOTE:A 2.5-inch hot swappable drive is installed in a 3.5-inch drive adapter, which is then installed in the 3.5-inch hot swappable drive carrier.

Steps

  1. Using a Phillips 1 screwdriver, remove the screws that secures the drive to the 3.5-inch drive adapter.
    NOTE: If the 2.5-inch drive has Torx screw, use Torx 6 screwdriver to remove the drive from a 3.5-inch drive adapter.
    Torx screw image
  2. Remove the drive from the 3.5-inch drive adapter.
    Figure 1. Removing a 2.5-inch drive from the 3.5-inch drive adapter
    This image show how to remove a 2.5 inch drive from the 3.5 inch drive adapter.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\