Dell PowerEdge T360 Installation and Service Manual

Removing the processor

WARNING:The processor will be hot to touch for some time after the system has been powered down. Allow the processor to cool before removing it.

CAUTION:The processor is held in its socket under strong pressure. Be aware that the release lever can spring up suddenly if not firmly held.

NOTE:Only remove the processor if you are replacing the processor or system board. This procedure is not required when replacing a heat sink module.

Release the socket lever by pushing the lever down and out from under the tab on the processor shield.
Lift the lever upward until the processor shield lifts.
CAUTION:The processor socket pins are fragile and can be permanently damaged. Be careful not to bend the pins in the processor socket when removing the processor out of the socket.
Lift the processor out of the socket.
NOTE:Ensure that the processor and the bracket are placed in the tray after you remove the heat sink.
Figure 1. Removing the processor