Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge T360 Installation and Service Manual

PDF

Installing the cabled PSU

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Unpack the replacement PSU.

Steps

  1. Slide the PSU into the PSU cage and align with screw hole on the PSU cage.
  2. Using the Phillips 2 screwdriver, tighten the screw that secures the PSU into PSU cage.
    Figure 1. Installing the cabled PSU
    This image shows how to install a cabled power supply unit.
  3. Tilt at an angle and insert the PSU cage into the slots on the system then slide it towards the rear of the system until the PSU cage is fully seated.
  4. Using the Phillips 2 screwdriver, tighten the screws that secure the PSU cage into the system.
    Figure 2. Installing the PSU cage
    This image shows installing PSU cage into the system

Next steps

  1. Connect all the power cables from the PSU to the system board and the drive backplane.
  2. Route the power cables properly and secure them with cable clips.
  3. Connect all the power cables from the PSU to the system board and the drive backplane.
  4. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\