Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge T360 Installation and Service Manual

PDF

Installing the BOSS-N1 card carrier

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions .
  2. Follow the procedure that is listed in .Before working inside your system
  3. If installed, remove the front bezel.

Steps

  1. Press the release clip and pull the BOSS-N1 card carrier blank out of the system.
    Figure 1. Removing the BOSS-N1 card carrier blank
    This image shows the removal of the BOSS-N1 card carrier blank.
  2. Align the M.2 NVMe SSD at an angle with the BOSS-N1 card carrier.
  3. Insert the M.2 NVMe SSD until it is firmly seated in the BOSS-N1 card carrier.
  4. Using the Phillips 1 screwdriver, secure the M.2 NVMe SSD on the BOSS-N1 card carrier with the M3 x 0.5 x 4.5 mm screw.
    Figure 2. Installing the M.2 NVMe SSD
    Installing the M.2 NVMe SSD
  5. Align and push the BOSS-N1 card carrier into the slot in the BOSS-N1 module.
  6. Close the release latch to secure the BOSS-N1 card carrier.
    Figure 3. Installing the BOSS-N1 card carrier
    This image shows the installation of the BOSS-N1 card carrier.

Next steps

  1. If removed, install the front bezel.
  2. Follow the procedure that is listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\