Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge T360 Installation and Service Manual

PDF

Removing the BOSS-N1 card carrier

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure that is listed in Before working inside your system.
  3. If installed, remove the front bezel.

Steps

  1. Open the release latch and slide the BOSS-N1 card carrier out of the BOSS-N1 module.
    Figure 1. Removing the BOSS-N1 card carrier
    This image shows the removal of the BOSS-N1 card carrier.
  2. Using the Phillips 1 screwdriver removes the M3 x 0.5 x 4.5 mm screw that secures the M.2 NVMe SSD to the BOSS-N1 card carrier.
  3. Slide the M.2 NVMe SSD out from the BOSS-N1 card carrier.
    Figure 2. Removing the M.2 NVMe SSD
    Removing the M.2 NVMe SSD
  4. If not installing the BOSS-N1 card carrier, align and push the BOSS-N1 card carrier blank into the BOSS-N1 module to fill the empty BOSS-N1 card carrier slot.
    Figure 3. Installing the BOSS-N1 card carrier blank
    This image shows the installation of the BOSS-N1 card carrier blank.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\