- Notes, cautions, and warnings
- About this document
- PowerEdge R940xa system overview
- Initial system setup and configuration
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Front bezel
- Drives
- System cover
- Support bar
- Cooling fans
- Cooling fan assembly
- Optional USB 3.0 module
- Optional optical drive
- Control panel
- Air shroud
- NVDIMM-N battery
- Drive backplane
- System memory
- Processors and heat sinks
- Expansion cards and expansion card risers
- Expansion card installation guidelines
- Removing the expansion card riser
- Installing the expansion card riser
- Removing the expansion card from the riser
- Installing the expansion card in the riser
- Removing the expansion card from the system board
- Installing the expansion card on the system board
- GPU card installation guidelines
- Removing the GPU
- Installing the GPU
- M.2 SSD module
- Optional IDSDM or vFlash module
- Network daughter card
- System battery
- Optional internal USB memory key
- Power supply units
- Power interposer board
- Trusted Platform Module
- System board
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Dell EMC PowerEdge R940xa Installation and Service Manual
Initializing TPM for BitLocker users
Steps
- Initialize the TPM.
For more information, see initializing the TPM for Intel TXT users.
- The TPM Status changes to Enabled, Activated.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\