An
optional USB memory key installed inside your system can be used as
a boot device, security key, or mass storage device. To boot from
the USB memory key, configure the USB memory key with a boot image
and then specify the USB memory key in the boot sequence in System
Setup.
An optional USB memory key can be installed in the
internal USB 3.0 port. The USB 3.0 module cable connects to the internal USB port on the system board. To locate the internal USB port, see the system board connectors.
The internal USB memory key is supported only in the 8 x 2.5 inch hard-drive configuration.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\