Dell EMC PowerEdge R940xa Installation and Service Manual

Installing the USB 3.0 module

1. Route the power and the USB cables on the USB 3.0 module through the USB 3.0 module slot on the front of the system.
2. Insert the USB 3.0 module into the slot on the front panel.
3. Align the screw on the module with the screw hole on the system.
4. Using a Phillips #2 screwdriver, tighten the screw to secure the module to the system.
5. Route and connect the USB cable to the internal USB port and power cable to the system board.

   
   

   

   
   

   NOTE To locate the connector, see System board connectors.