Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge R940xa Installation and Service Manual

PDF

Removing the USB 3.0 module

Steps

  1. Disconnect the cables from the system board.
  2. Using a Phillips #2 screwdriver, loosen the screw on the USB 3.0 module.
  3. NOTE Observe the routing of the cable as you remove it from the system. Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
    Slide the USB 3.0 module out of the system.
    Figure 1. Removing USB 3.0 module

    Removing USB 3.0 module

Next steps

  1. Replace the USB 3.0 module or the USB 3.0 blank.
    NOTE The procedure to remove a USB 3.0 blank is similar to the USB 3.0 module.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\