Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge R940xa Installation and Service Manual

PDF

Removing the Air Shroud C

Prerequisites

CAUTION Ensure that the riser 1 cables do not get pinched or crimped while placing the air shroud C.
  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the support bar.
  4. Remove the air shrouds A.
  5. Remove the NVDIMM-N battery, if installed.
  6. Remove the air shroud B.

Steps

  1. Release the cables from the cable retention clips on the shroud.
  2. Disengage the air shroud from the retention tabs on the left side of the chassis wall.
  3. Lift the air shroud out of the system.
    Figure 1. Removing the Air Shroud C

    Removing the Air Shroud C

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\