Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge R940xa Installation and Service Manual

PDF

Removing the expansion card from the riser

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the support bar.
  4. Remove the air shrouds.
  5. Remove the expansion card riser.

Steps

  1. Press and slide the release button upwards to lift the cover.
  2. Open the card retention latch.
  3. Lift the card to disengage it from the connector on the riser.
    Figure 1. Removing the expansion card from the riser

    Removing the expansion card from the riser

Next steps

  1. Install a filler bracket if you are not going to replace the expansion card.
    NOTE You must install a filler bracket over an empty expansion card slot to maintain Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system.
  2. Replace the expansion card in the riser.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\