Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge R940xa Installation and Service Manual

PDF

Installing the network daughter card

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the support bar.
  4. Remove the air shrouds.
  5. Remove the expansion card riser.

Steps

  1. Align the connectors on the NDC with the slots on the chassis.
  2. Press the blue touch points until the card connector is firmly seated on the system board connector.
  3. Using a Phillips #2 screwdriver, tighten the captive screws to secure the NDC to the system board.
    Figure 1. Installing the network daughter card

    Installing the network Daughter card

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\