- Notes, cautions, and warnings
- About the Shared PERC 8 card
- Shared PERC
8 card features
- Physical disk power management
- Consistency Checks
- Virtual disk initialization
- Physical disk roaming
- FastPath
- Virtual disk migration
- Virtual disk cache policies
- Physical disk write cache policy
- Fault tolerance
- Multipath support
- Deploying the Shared PERC 8 card
- Driver installation
- Downloading drivers and firmware for Shared PERC 8 from the Dell support website for all operating systems
- Downloading drivers from the Dell Systems Service and Diagnostic Tools media for Windows
- Installing or updating Windows drivers for Shared PERC 8
- Installing or updating Linux drivers for Shared PERC 8
- Installing or updating VMware drivers for Shared PERC 8
- Multipath and clustering setup
- Management applications for Shared PERC 8 card
- Troubleshooting
- Performance variations between write-back and write-through cache modes
- Shared PERC 8 card boots into safe mode
- Degraded state of virtual disks
- General issues
- Physical disk
issues
- Incorrect Number of Virtual Disks Displayed In Windows Disk Manager
- Physical Disk In Failed State
- Unable to rebuild a fault tolerant virtual disk
- Fatal Error Or Data Corruption Reported
- Physical Disk Displayed As Blocked By Management Application
- Multiple Disks Become Inaccessible
- Rebuilding A Failed Physical Disk
- Virtual Disk Fails During Rebuild Using A Global Hot Spare
- Virtual Disk Fails During Rebuild Using A Dedicated Hot Spare
- Physical disk takes a long time to rebuild
- Controller cache issues
- SMART Errors
- Auto Replacement Member Errors
- Hard-Drive Indicator Patterns
- Getting help
Dell Shared PowerEdge RAID Controller (PERC) 8 For Dell PowerEdge VRTX Systems User’s Guide
Conditions for replacing the battery
The Shared
PERC 8 battery is marked
Failed in the
Battery Status in the CMC, when the state or health of
the battery is declared bad. If battery is declared failed, then the
firmware runs learn cycles in subsequent reboots until the battery
is replaced. After the battery is replaced, the virtual disk then
transitions to write-back mode.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\