- Notes, cautions, and warnings
- About the Shared PERC 8 card
- Shared PERC
8 card features
- Physical disk power management
- Consistency Checks
- Virtual disk initialization
- Physical disk roaming
- FastPath
- Virtual disk migration
- Virtual disk cache policies
- Physical disk write cache policy
- Fault tolerance
- Multipath support
- Deploying the Shared PERC 8 card
- Driver installation
- Downloading drivers and firmware for Shared PERC 8 from the Dell support website for all operating systems
- Downloading drivers from the Dell Systems Service and Diagnostic Tools media for Windows
- Installing or updating Windows drivers for Shared PERC 8
- Installing or updating Linux drivers for Shared PERC 8
- Installing or updating VMware drivers for Shared PERC 8
- Multipath and clustering setup
- Management applications for Shared PERC 8 card
- Troubleshooting
- Performance variations between write-back and write-through cache modes
- Shared PERC 8 card boots into safe mode
- Degraded state of virtual disks
- General issues
- Physical disk
issues
- Incorrect Number of Virtual Disks Displayed In Windows Disk Manager
- Physical Disk In Failed State
- Unable to rebuild a fault tolerant virtual disk
- Fatal Error Or Data Corruption Reported
- Physical Disk Displayed As Blocked By Management Application
- Multiple Disks Become Inaccessible
- Rebuilding A Failed Physical Disk
- Virtual Disk Fails During Rebuild Using A Global Hot Spare
- Virtual Disk Fails During Rebuild Using A Dedicated Hot Spare
- Physical disk takes a long time to rebuild
- Controller cache issues
- SMART Errors
- Auto Replacement Member Errors
- Hard-Drive Indicator Patterns
- Getting help
Dell Shared PowerEdge RAID Controller (PERC) 8 For Dell PowerEdge VRTX Systems User’s Guide
Shared PERC 8 Card Not Seen In Device Manager
- Issue:
- The device does not appear in the Device Manager.
- Corrective Action:
- In the Dell Chassis Management Controller (CMC) application, verify
if the Shared PERC 8 is correctly mapped to the server module. For
more information on assigning virtual adapters to server slots, see
the
Dell Chassis Management Controller for Dell PowerEdge VRTX
User’s Guide
at
dell.com/poweredgemanuals.
- NOTE: Make changes to Virtual Adapter to Server Slot mapping only when the server modules are turned off.
If the Virtual Adapter to Server Slot mapping is correct and the device still does not appear in the Device Manager, turn off the system and reseat the Shared PERC 8 card.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\