- Notes, cautions, and warnings
- About the Shared PERC 8 card
- Shared PERC
8 card features
- Physical disk power management
- Consistency Checks
- Virtual disk initialization
- Physical disk roaming
- FastPath
- Virtual disk migration
- Virtual disk cache policies
- Physical disk write cache policy
- Fault tolerance
- Multipath support
- Deploying the Shared PERC 8 card
- Driver installation
- Downloading drivers and firmware for Shared PERC 8 from the Dell support website for all operating systems
- Downloading drivers from the Dell Systems Service and Diagnostic Tools media for Windows
- Installing or updating Windows drivers for Shared PERC 8
- Installing or updating Linux drivers for Shared PERC 8
- Installing or updating VMware drivers for Shared PERC 8
- Multipath and clustering setup
- Management applications for Shared PERC 8 card
- Troubleshooting
- Performance variations between write-back and write-through cache modes
- Shared PERC 8 card boots into safe mode
- Degraded state of virtual disks
- General issues
- Physical disk
issues
- Incorrect Number of Virtual Disks Displayed In Windows Disk Manager
- Physical Disk In Failed State
- Unable to rebuild a fault tolerant virtual disk
- Fatal Error Or Data Corruption Reported
- Physical Disk Displayed As Blocked By Management Application
- Multiple Disks Become Inaccessible
- Rebuilding A Failed Physical Disk
- Virtual Disk Fails During Rebuild Using A Global Hot Spare
- Virtual Disk Fails During Rebuild Using A Dedicated Hot Spare
- Physical disk takes a long time to rebuild
- Controller cache issues
- SMART Errors
- Auto Replacement Member Errors
- Hard-Drive Indicator Patterns
- Getting help
Dell Shared PowerEdge RAID Controller (PERC) 8 For Dell PowerEdge VRTX Systems User’s Guide
Management applications for Shared PERC 8 card
The Dell Chassis
Management Controller (CMC) enables you to:
- Configure the shared RAID system
- Create and manage multiple disk groups
- Control and monitor multiple RAID systems
- Provide online maintenance through a web interface or Command Line Interface (CLI)
- NOTE: Dell OpenManage Storage Management, BIOS Configuration Utility ( <Ctrl> <L>), or Unified Extensible Firmware Interface (UEFI) RAID Configuration Utility does not support the Shared PERC 8 and may only be used to manage non-shared PERC cards. For non-shared PERC cards, see the system-specific PERC User's Guide at dell.com/storagecontrollermanuals.
For more information on the CMC web interface or CLI commands available for Shared PERC 8, see the Dell Chassis Management Controller for Dell PowerEdge VRTX User’s Guide at dell.com/esmmanuals.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\