Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell Shared PowerEdge RAID Controller (PERC) 8 For Dell PowerEdge VRTX Systems User’s Guide

PDF

Removing the Shared PERC 8 card

  • CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the system.
  • CAUTION: Shared PERC 8 cards are not hot-swappable. Do not remove or install the Shared PERC 8 cards from the system board while the PowerEdge VRTX system is powered on.
To remove the Shared PERC 8 card:
  1. Push down the two release levers at the edge of the Shared PERC 8 card to disengage the card from the storage-controller card holder.
  2. Orient the card so that the other end of the card disengages from the storage-controller card holder on the system board.
    • CAUTION: When removing or replacing the Shared PERC 8 card, hold the card by its edges. Do not handle the card while holding the battery or the heatsink.
    Figure 1. Removing and installing the Shared PERC 8 card The figure shows removing and installing the Shared PERC 8 card.
    1. release lever (2)
    2. storage-controller card holder
    3. storage controller card
    4. battery
    5. heatsink
    6. touch points (2)
    7. storage-controller card connector on the system board
    8. guide pins (2)

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\