Dell PowerVault ME4 Series Storage System CLI Guide

show ipv6-network-parameters


Description	Shows the IPv6 settings and health of each controller module's network port.
Minimum role	monitor
Syntax	show ipv6-network-parameters
Output	Autoconfig enabled: Uses an IPv6 address computed by SLAAC or assigned by a DHCPv6 server, depending on the network configuration. If a DHCPv6 address is available, then that address is used. Otherwise SLAAC is used. disabled: Uses static IPv6 addresses set with the add ipv6-address command. Gateway The network port gateway IPv6 address. Link-Local Address The link-local IPv6 address. Autoconfig IP The automatically configured IPv6 address. IPv6 Address (1-4) Shown if Autoconfig is disabled. Shows between one and four manually set IPv6 addresses. IPv6 Label (1-4) Shown if Autoconfig is disabled. Shows the user-defined name, if set, for each manual IPv6 address.
Examples	Show IPv6 network parameters for each controller module. # show ipv6-network-parameters
Basetypes	ipv6-network-parameters status
See also	set ipv6-network-parameters