Dell VxRail VD-4510c Hardware Requirements and Specifications

PDF

Configure memory settings

To view the Memory Settings screen, power on the system, and press F2.
Click System Setup Main Menu > System BIOS > Memory Settings.

Use the following table to configure memory settings:


Option	Description
System Memory Size	Specifies the size of the system memory.
System Memory Type	Specifies the type of memory installed in the system.
System Memory Speed	Specifies the speed of the system memory.
System Memory Voltage	Specifies the voltage of the system memory.
Video Memory	Specifies the size video memory.
System Memory Testing	Specifies whether the system memory tests are run during system boot. The two options available are Enabled and Disabled (default).
Memory Operating Mode	Specifies the memory operating mode. The option is available and is set to Optimizer Mode, by default. Options such as Fault Resilient Mode and NUMA Fault Resilient Mode are available for support when the Advanced RAS capability processor is installed on the system.
Current State of Memory Operating Mode	Specifies the current state of the memory operating mode.
Node Interleaving	Enables or disables the Node interleaving option. Specifies if the Non-Uniform Memory Architecture (NUMA) is supported. If this field is set to Enabled, memory interleaving is supported if a symmetric memory configuration is installed. If the field is set to Disabled (default), the system supports NUMA (asymmetric) memory configurations.
Memory training	When option is set to Fast and memory configuration is not changed, the system uses previously saved memory training parameters to train the memory subsystems and system boot time is also reduced. If memory configuration is changed, the system automatically enables Retrain at Next boot to force one-time full memory training steps, and then go back to Fast afterward. When option is set to Retrain at Next boot, the system performs the force one-time full memory training steps at next power on and boot time is slowed on next boot. When option is set to Enable, the system performs the force full memory training steps on every power on and boot time is slowed on every boot.
Memory Map Out	Enables (default) or disables DIMMs slots on the system.
Correctable Error Logging	Enables or disables (default) correctable error logging.
DIMM Self Healing (Post Package Repair) on Uncorrectable Memory Error	Enables (default) or disables Post Package Repair (PPR) on uncorrectable memory error.