Verify that the password jumper is enabled. The password jumper enables or disables the system password and setup password features. For more information, see the System board jumper settings section.
NOTE:If the password jumper setting is disabled, the existing system password and setup password are deleted. To boot the system, you need not provide the system password.
About this task
A password can have up to 32 characters.
Steps
To enter
System Setup, press
F2 immediately after turning on or rebooting your system.
On the
System Setup Main Menu screen, click
System BIOS > System Security.
On the
System Security
screen, verify that
Password Status is set to
Unlocked.
In the
System Password field, enter your system password, and press
Enter or
Tab.
Reenter the system password, and click
OK.
In the
Setup Password field, enter your setup password and press
Enter or
Tab.
Reenter the setup password, and click
OK.
Press Esc to return to the
System BIOS screen. Press
Esc again.
A message prompts you to save the changes.
NOTE:Password protection does not take effect until the system reboots.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\