- Notes, cautions, and warnings
- Revision history
- Introduction
- Configurations and features
- Initial setup and configuration
- Pre-operating system management applications
- Manage the pre-operating system applications
- Set up the system
- Configure system BIOS settings
- Configure system Information
- Configure memory settings
- Configure the processor
- Set the NVMe drive mode
- Configure the boot mode
- Configure network settings
- Configure integrated devices
- Configure serial communication
- Configure the system profile
- System security overview
- Configure redundant operating system control
- View miscellaneous settings
- iDRAC and device settings
- Configure system BIOS settings
- Dell Lifecycle Controller
- Boot Manager
- PXE boot
- Set up the system
- iDRAC configuration
- Manage the pre-operating system applications
- Minimum configuration to POST
- Technical specifications
- Component replacement guidelines
- Jumpers and connectors
- Use system diagnostics
Dell VxRail VD-4510c Hardware Requirements and Specifications
Minimum configuration to POST
This section outlines the minimum configuration necessary for VxRail VD-4510c to run power-on self-test (POST).
The components that are listed below are the minimum configuration to POST:
- Four memory modules (DIMM)
- Two power supply units (PSUs)
- VxRail VD-4000r or VxRail VD-4000z chassis (Power Interposer Board, cables)
- System board
- VxRail VD-4510c sled
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\